CRYSTALIDEA Forums

It's been working perfectly all week. I think you fixed it. Thanks!

It's been working all morning on fixed RPM. Looking good so far. The installer froze at "initializing" but I ended the process and rebooted and everything seems OK. Here's today's log: INFO 2013-07-22T09:55:22.161 "QMySysInfo::machineName ('')" INFO 2013-07-22T09:55:22.161 "...

I take back what I said about sensor based working. It also eventually fails. Here's the log using fixed RPM INFO 2013-07-19T16:28:53.739 "QMySysInfo::machineName ('')" INFO 2013-07-19T16:28:53.739 "Starting on MacBookPro10,1" INFO 2013-07-19T16:28:53.839 "QMySysInfo::machin...

1. Automatic seemed to be fine. Interestingly Sensor mode seemed to be fine too. 2. When I switched one fan to constant rpm, the values all went to zero after a few minutes. Closing mfc and bootcamp.exe and restarting mfc did not work. I observed that when mfc restarted it was very slow to populate ...

I tried a few things. Ending the bootcamp.exe process does allow Fan Control to run normally. If I start bootcamp.exe, Fan Control will eventually stop reading the values in under an hour. Only a reboot can get it back. The two Apple services don't seem to matter. If I leave bootcamp.exe running, an...

I checked my SMC in this KB. It's up to date.

Are there any alternative programs out there that read/monitor the same values?

I have this exact same issue. Today running the latest. I have my fans set for fixed RPM. After an hour I'd say they show zero rpm. The temps were there, then I looked again and the temps all show 0 except for the SSD which seems to always register a temp. I don't know what to look for in terms of c...