We have discontinued this forum and moved support tickets to the GitHub issue tracker. More info

Update dialog still showing after update

Control fans on Apple hardware: iMacs, Macbooks, etc

Moderator: Steven

Post Reply
Jathemez
Posts: 2
Joined: 30 Sep 2016, 19:25

Update dialog still showing after update

Post by Jathemez »

Today I launched up my mac and, as usual, went to push the fan to full force while building some apps. Usually it's fine, but it said that there was an update and I was a version behind. I clicked the link and also started the program to turn it on, but found that it was reporting min and max speeds of 0rpm.

Oh well, that should just be an issue in the update and, if not, I'll just reset the SMC as advised.

Updated and started it only to find the same update dialog. Checked version: 1.4.3. That's the best I could find on the site.

Anyone else having this issue? Still getting 0 rpm for min, max and current, but that's probably unrelated.
User avatar
Steven
CrystalIDEA Developer
Posts: 2294
Joined: 21 Dec 2009, 11:48
Location: CrystalIDEA headquarters
Contact:

Update dialog still showing after update

Post by Steven »

Dear sir,

Please re-download version 1.4.4, it must be fixed now.

thanks
Jathemez
Posts: 2
Joined: 30 Sep 2016, 19:25

Update dialog still showing after update

Post by Jathemez »

Steven wrote:Dear sir,

Please re-download version 1.4.4, it must be fixed now.

thanks
Cheers mate.

That seemed to have fixed not only the update error from that other thread, but the 0 rpm error too.

Thanks for the good software :)
cvvmax
Posts: 4
Joined: 30 Sep 2016, 16:26

Update dialog still showing after update

Post by cvvmax »

Where is V1.4.4 located?

Because the version on your main website is v1.4.3 although right above the link, it says v.1.4.4.

Please advise so I may fix the issue with v1.4.3, which does NOT work
User avatar
Steven
CrystalIDEA Developer
Posts: 2294
Joined: 21 Dec 2009, 11:48
Location: CrystalIDEA headquarters
Contact:

Update dialog still showing after update

Post by Steven »

Post Reply