CRYSTALIDEA Forums

One thing I liked about smcFanControl is that I was able to save a set of fan RPMs as a group.

For example, I had a setting called 50% RPM that I set by moving the sliders 50% of the way above default on all four fans.

Is it possible to save setting as ground as described above that I can manually select?

Thanks.

Ok, I set the Macs Fan Control 'control' settings to Based on Ambient > Sensor-based Value for all four fans.

I am using the default 'temperature that the fan speed will start to increase from' and the default 'maximum temperature' settings.

Just want to make sure this is the best way to control the fan speeds.

Lately it has been 95 to 100 F (35 to 38 C) here.

Thank in advance for our advise.

Steven wrote:http://forums.crystalidea.com/viewtopic.php?f=11&t=911

I am in deadly hunger for new version that I check the forum every day to see if there's new release!

DreamSeason
I guarantee you'll be the first to test it out!

Steven wrote:DreamSeason
I guarantee you'll be the first to test it out!

Hi, Steven. It's August already. Any updated info on the development?

Sorry, it won't be faster if you keep asking Follow our twitter to be the first.

Steven wrote:Sorry, it won't be faster if you keep asking Follow our twitter to be the first.

I will watch the twitter instead. Keep up the good work!